ETA Centrino s doplňkovým příslušenstvím User Manual

Page 35

Advertising
background image

– Never immerse the drive unit into water and do not wash it in running water!

– Never leave the appliance unsupervised, unfilled and check it during the whole

time of preparing meals!

– Always unplug the appliance from power supply if you leave it unattended.

– Use the appliance in the working position only at places with no risk of turning over and

in sufficient distance from heat sources (e.g.

heater, electric/gas stove, cooker, etc.)

and wet surfaces (e.g.

sinks, wash basins, etc.)

– Before preparation, remove possible packages from food (e.g.

paper, a PE bag, etc.).

– do not switch on the appliance without ingredients put in!

– Use the appliance with accessories intended for this type only. Using another appliance

can represent a risk for the operator.

– do not insert the appliance into any body holes.

– Never put fingers in the filling hole and do not use a fork, a knife, a spatula,

a spoon etc. for the same. Use only the provided pusher for this purpose.

– Proper mounting of the bowl, the bowl lid, the big pusher, the blender and the citrus press

will release safety locks and you can switch the appliance on.

The appliance cannot be

started without the mounted bowl, lid, big pusher, blender or citrus press.

– do not use safety locks controlled by the bowl, the bowl lid, the big pusher and the citrus

press and a safety lock controlled by the blender for switching off the appliance!

– Remove the blade protector from the knife before use.

– For safety reasons, the work adapters cannot be replaced when the drive unit is in

operation.

– Before you remove the lid or the blender bowl, let the rotating parts stop completely.

– When mounting or removing the bowl, do not apply much pressure on the bowl handle.

– do not lift and carry the food processer using the bowl handle, but always use the

moulded holes in the bottom of the drive unit!

– do not process food at temperature exceeding

about 80 °C (176 °F). When blending hot

liquids, remove plug

E3 from the blender lid.

– When mixing or blending liquids, never put in bigger amount than specified on the bowl.

– If the processed food starts to stick to the appliance (e.g.

on knives, graters), switch off

the appliance and clean the accessories carefully (e.g.

using a spatula).

– Make sure that the power cord does not get in contact with the rotating part of the

appliance.

– Check the condition of the power cord of the appliance regularly.

– The power cord must not be damaged with sharp or hot objects, open fire, it must not

be sunk into water or bent over sharp edges. Never put it on hot surfaces or do not let

it hang over the edge of a table or work tables. Hitting, stumbling or pulling the power

cord e.g. by children can result in tilting over or drawing the appliance down and serious

injury!

– If you need to use an extension cord, it has to be uncorrupted and it has to comply with

the valid standards.

– Use the appliance only with original accessories from the manufacturer.

– Use the appliance only for the purpose it is intended for as specified in this manual.

Never use the appliance for any other purpose.

– The manufacturer is not responsible for damage and injuries caused by improper use

of the appliance and the accessories (e.g.

food deterioration, injury, cutting) and its

guarantee for the appliance does not apply in situations when the safety warnings above

are not complied with.

35

GB

/ 117

Advertising
This manual is related to the following products: