ETA Centrino s doplňkovým příslušenstvím - Manual (Page 41)

- Always cut big pieces beforehand so that they get into the filling hole.
- Put in the ingredients one after another and equally.
- Always move food in the filling hole using the pusher only, move it slowly and to not push
downwards too much.
- If food is grated roughly (e.g. breadcrumbs), use the sickle-shaped knife for finer
grinding.
- When grating or granulating soft ingredients, use low speed so that ingredients do not
turn into a mash.
- Use sickle-shape knife H that is also intended for chopping (grinding) for food that you
usually grate ( hard cheese, nuts, chocolate).
- The preparation (processing) times depend on the amount, the kind and the quality of
used ingredients, but as a standard they are in tens of seconds.
When assembling all necessary parts of the blender and for filling the blender with food,
switch on the appliance by turning regulator A1 from OFF position (the appliance is off) to
ON position (the appliance is ON), (backlight of buttons A2 and A3 will start flashing). Start
by turning regulator to the required speed level or by pushing button A2. When you have
finished, switch off the appliance by turning the regulator to the OFF position (the appliance
is OFF), (backlight of buttons A2 and A3 will go out), then unplug power cord A8 from the
electric socket.
Citrus press (Fig. 9)
Mounting and removing pressing sieve (G)
Remove and mount the pressing sieve only when turning regulator A1 is in the OFF
position.
Set the sieve on bowl B so that it fits exactly into the protruding part on the edge of the
bowl. Turn the adapter to the right till securing lug G1 snaps shut to the lock of safety
device A5. Pay special attention to this operation. The adapter is now secured in the
proper position and drive unit A can work. Put on pressing cone G2 and push it. You can
remove the lid in the opposite direction.
CAUTION: Never turn the appliance without crimping mandrel mounted!
Use
It is used for pressing citrus fruits (e.g. oranges, lemons or grapefruits).
Turning regulator A1 used. Setting regulator: MIN to the first half of the scope.
After assembling the press, cut the citrus fruit in half and push it on pressing cone G2.
Switch on the appliance by turning regulator A1 from the OFF position (the appliance is off)
to the ON position (the appliance is on) (backlight of buttons A2 and A3 will start flashing).
You will start juicing by turning the regulator to the required speed level. The pressing
cone is turning and the juice is squeezed and flows on the cone through the sieve to the
bowl. When you have finished, switch off the appliance by turning the regulator to the OFF
position, then unplug power cord A8 from the electric socket.
Recommendation:
– The amount of squeezed juice has to be checked. It cannot exceed the maximum level of
the bowl volume marked with a gauge line. empty the bowl in time.
– If you process bigger amount of food, we recommend regular removing of the
accumulated pulp from the sieve.
41
GB
/ 117