Fat Bagger 200MM FAT TIRE KIT 2008 - Manual (Page 12)

www.fatbaggers.com 641-774-7499
23. Tighten rear backrest mounting hardware again if there is any adjustment.
24. Now remove and reinstall backrest making sure there is now binding. If there is binding, pres-
ent loosen your new FBI100 fender strut brackets, pull or push forward and back as needed to make
backrest install smoothly and easily and reinstall fender support brackets bolts.
25. Leave rear backrest mount installed, remove front rubber mount. NOTE: You must spread back-
rest apart to fit over FBI fender you can pull apart by hand. Be careful installing over painted fender.
26. Drilling frame for fender fitment. Use 1/8 drill bit to drill through frame where front backrest
rubber mount bolt is located, go through threaded hole, drilling through inside of frame, repeat on
other side.
27. With 3/16 drill bit go through the hole where the front saddlebags support bracket was located.
And start drilling through the inside of the frame.