Fat Bagger 200MM FAT TIRE KIT 2008 - Manual (Page 14)

www.fatbaggers.com 641-774-7499
Drilling pilot holes. Use a 21-64
drill bit. Drilling pilot holes.
Fiberglassed seat bolt
installed. Seat bolt in position.
32. Remove fender
33. Drill pilot holes out with a 21/64 drill bit.
34. Before painting fender, install part# FBI101, into fender for mounting a two up seat, the fender
has marked indentation on fender where you need to drill use drill bit. Use plastic clip off of factory
seat to hold in place FBI101, then you can fiberglass or epoxy the seat bolt stud to fender on
fiberglass. If you received a painted fender this step has already been done for you.
35. Now your fender is ready for painting, after fender is painted you are ready to install FBI860.
Turn fender upside down on something soft. Use a 60 second epoxy (is included) to install the
taillight. With fender upside down place taillight into hole, use cardboard shims to shim taillight until
it is flush with outside of fender, then apply 60 second epoxy through the holes on each side of
taillight. We recommend scuffing the inside of fender, so the epoxy with properly adhere to inside of
fender. Then use RVT silicon go around taillight to water tight taillight to fender. Then place wiring
into clips on inside of fender. NOTE: Use instructions provided with FBI860 for wiring 2008 bikes
have to have wire placed different in the plug. Too wire the taillight take the white connector, and
take slot 4 and 5 and reverse them so that 4 will now be 5 and 5 will now be 4.