Fat Bagger 200MM FAT TIRE KIT 2008 - Manual (Page 18)

www.fatbaggers.com 641-774-7499
46. Before installing the rear wheel, you will need to remove the 08” pulley and bolts from the
wheel. This is where you need to install the 2008 Upgrade Kit pulley and bolts for proper fitment.
Slide wheel into position. Wheel in position and ready for
rear axle to be installed.
Rubber bumpers installed on
rear fender.
45. Now install 3 rubber bumpers on filler strips as show in fig this will prevent saddlebags coming
contact with fender.
46.5 Remove saddlebag again. Install rear wheel, with sprocket on, rotor off. NOTE: If using 17
inch rim, you must grind corner of caliper off to make sure it does not contact rim.
Install 2008 Upgrade Kit pulley
and pulley bolts.