Fire Magic 3287-1(P) Searing Station Built in - Manual (Page 9)

FLAME PATTERN
SEARING STATION FLAME PATTERN
A layer of fl ame may just be visible above the ceramic grid of the searing station burner especially around
the edges. The fl ame will initially appear mostly blue with perhaps a few yellow fl ashes. Soon the red glow
of the ceramic will be the primarily visible color of the burner top. Though there may be small areas of
lesser or greater intensity, the overall red color will become fairly even after about three to fi ve minutes.
GENERAL INFORMATION
SAFETY TIPS IN USING THE SEARING STATION
Each time you use the Searing Station, ensure that:
1. The area around the unit is clear and free from fl ammable vapors, liquids, and other combustible materials.
2. There is no blockage of airfl ow around the burner .
3. When using propane gas, ensure that:
a. The special ventilation openings in the enclosure are kept free and clear of debris.
b. If connected to a propane cylinder, inspect the rubber hose attached to the regulator before each use.
c. Propane cylinder, regulator, and hose are installed in a location not subject to heating above 125°F (51° C).
4. Flame is burning evenly and steadily across the burner (mostly blue with yellow tipping).
Important: Do not operate the Searing Station with the cover closed.
CARE AND CLEANING
For cleaning purposes; always leave your burner on (after cooking) for an additional 5 minutes, to allow
for a burnoff period. This is important to keep your burner clean and operating properly.
As the burner is self cleaning (at full temperature); avoid the use of cleaner or abrasives.
CAUTION: Never use acid chemicals or abrasive pads to clean porcelain or aluminum surfaces.
9 L-C2-200 Rev 10 - 1401131145