Q-See QS408 - Manual (Page 42)

42
RESTORING FACTORY SETTINGS
STEP 1. Click DEFAULT SETTINGS. This will restore the system to the original factory
settings.
STEP 2. Click OK in the prompt.
RESTARTING THE DVR (SOFT-RESET)
STEP 1. Click RESTART.
STEP 2. Click OK in the prompt. The system will perform a soft-reset and load to a live
split-screen view.
UPGRADING THE FIRMWARE
STEP 1. Copy the firmware file to an
empty USB flash drive. The firmware
file should not be in a folder.
STEP 2. Connect the USB flash drive to
the top USB port on the front panel of
your system.
STEP 3. Open the System Menu.
STEP 4. Click FIRMWARE UPDATE.
The system will scan the USB
flash drive and begin updating the
firmware.
Do not remove the USB
flash drive while the upgrade is
taking place.
STEP 5. Click CLOSE in the confirmation
window. In the system prompt, click
OK. The system will restart.
PICTURE 6-7
IMPORTANT! Restoring factory settings will cause any settings you’ve made
to the system to be removed! This includes recording and network setups
along with passwords!