Q-See QS408 - Manual (Page 47)

47
CHAPTER 7 REMOTE ACCESS
PART 3: ACTIVATING UPnP in the
DVR
STEP 6. On the DVR, access the
Network menu from the Advanced
Settings menu.
TYPE
MEDIA PORT
WEB PORT DHCP
09000
00080
2 0 2 . 0 9 6 . 1 3 4 . 1 3 3
DEFAULT
DNS
DDNS SETTINGS UPNP OPEN CLOSE
APPLY EXIT
NETWORK SETUP
PICTURE 7-9
PICTURE 7-8
PICTURE 7-10
PICTURE 7-11
STEP 7. Set Network Type to DHCP
and click OPEN next to UPNP.
STEP 8. Click on Apply and then OK
to save your settings before exiting
this menu.
STEP 9. Restart your DVR.
STEP 10. Check the status of ports 80,
100 and 9000, by going to www.
canyouseeme.org and entering the
port numbers one at a time.
If you receive the “Success!”
message then you are ready to begin
remotely monitoring your DVR by
entering the IP address displayed by
CanYouSeeMe.
If you do not receive the “Success!” message, you should change the port number listed to
the right of Web Port (see
Picture 7-10 ) from 80 to 85 or 89 in the Network Settings Menu
and begin again with Step 8.