Flowserve 510si IOM Logix - Manual (Page 4)

4
1.6 Spare parts
Use only FLOWSERVE original spare parts.
FLOWSERVE cannot accept responsibility for any
damages that occur from using spare parts or
fastening materials from other manufactures. If
FLOWSERVE products (especially sealing materials)
have been on store for longer periods check these
for corrosion or deterioration before using these
products. Fire protection for FLOWSERVE products
must be provided by the end user.
1.7 Service / repair
To avoid possible injury to personnel or damage to
products, safety terms must be strictly adhered to.
Modifying this product, substituting nonfactory parts,
or using maintenance procedures other than outlined
in this instruction could drastically affect performance
and be hazardous to personnel and equipment, and
may void existing warranties. Between actuator and
valve there are moving parts. To avoid injury
FLOWSERVE provides pinch-point-protection in the
form of cover plates, especially where side-mounted
positioners are fitted. If these plates are removed for
inspection, service or repair special attention is
required. After completing work the cover plates must
be refitted.
Apart from the operating instructions and the
obligatory accident prevention directives valid in the
country of use, all recognised regulations for safety
and good engineering practices must be followed.
WARNING: Before products are returned to
FLOWSERVE for repair or service FLOWSERVE must
be provided with a certificate which confirms that the
product has been decontaminated and is clean.
FLOWSERVE will not accept deliveries if a certificate
has not been provided (a form can be obtained from
FLOWSERVE).
1.8 Storage
In most cases FLOWSERVE products are
manufactured from stainless steel. Products not
manufactured from stainless steel are provided with
an epoxy resin coating. This means that FLOWSERVE
products are well protected from corrosion.
Nevertheless FLOWSERVE products must be stored
adequately in a clean, dry environment. Plastic caps
are fitted to protect the flange faces to prevent the
ingress of foreign materials. These caps should not
be removed until the valve is actually mounted into
the system.
STOP!
1.9 Valve and actuator variations
These instructions cannot claim to cover all details
of all possible product variations, nor in particular
can they provide information for every possible
example of installation, operation or maintenance.
This means that the instructions normally include only
the directions to be followed by qualified personal
where the product is being used for is defined
purpose. If there are any uncertainties in this respect
particularly in the event of missing product-related
information, clarification must be obtained via the
appropriate FLOWSERVE sales office.
2 UNPACKING
Each delivery includes a packing slip. When
unpacking, check all delivered valves and accessories
using this packing slip.
Report transport damage to the carrier immediately.
In case of discrepancies, contact your nearest
FLOWSERVE location.