Flowserve MX-85 Actuator User Manual
Page 74
Advertising
Flow Control
Limitorque Actuation Systems
66
MX-85/140 Maintenance and Spare Parts
FCD LMAIM1341-00
STEP 10
Insert retaining ring (#1-21) into retaining ring
groove—snap retaining ring into groove by work-
ing a flat blade screwdriver around the edge of the
retaining ring until it seats into groove.
10
1-21
STEP 11
If contactor assembly was loosened in Step 7, then
remount contactor on screws (#8-28). Retighten
with M3 hex key.
11
STEP 12 AND 13
Connect incoming power leads and control wiring
according to application wiring diagram if terminal
block has been replaced.
Install the terminal compartment cover and secure with
four M8 screws using a 6 mm hex key.
12
Advertising
This manual is related to the following products: