Flowserve MX-85 Actuator - Manual (Page 86)

Flow Control
Limitorque Actuation Systems
78 MX-85/140 Maintenance and Spare Parts FCD LMAIM1341-00
5.9.2 Remounting
STEP 3
Work the three connectors through the hole/slot
in the housing. (Hole/slot is located in the motor
cavity next to the worm shaft bore.) Thread the
three connectors through the housing into the
controls compartment cavity until the lead seal fits
completely into the hole/slot in the housing.
3a
3b
STEP 4
Remount all removed subassemblies according to
the remounting instructions in the following order.
1. Contactor assembly (subassembly #8).
(See Section 5.6.1)
2. Control module (subassembly #15).
(See Section 5.2.1)
3. Accutronix control panel (subassembly #7).
(See Section 5.1.)
4. Motor (subassembly #4). (See Section 4.1.1)