Fluke Biomedical QED 6 - Manual (Page 16)

QED 6
Users Guide
1-4
Unpacking and Inspection
Use the following checklist when unpacking the Analyzer to check for damage
during shipment. If the Analyzer has been damaged, call your Fluke
Biomedical representative immediately. If you must return the Analyzer to
Fluke for service, follow the procedure given under Packing Instructions.
• Perform a visual inspection to ensure the front panel and case are intact.
• Check the LCD display to ensure that it is unbroken.
• Place the Analyzer on a level surface and power up the instrument. If the
message, WARNING - LOW BATTERY!! appears on the display, replace
the battery.
General Safety Considerations
Read the Users Manual before operating the Analyzer.
Symbols
Table 1-1 describes the symbols associated with the Analyzer.
Table 1-1. Symbols
Symbol Description
W Important information; refer to manual.
~ Do not dispose of this product as unsorted municipal waste. Go
to Fluke’s website for recycling information.
;
Conforms to relevant Australian EMC requirements
X Hazardous voltage
P Conforms to European Union directives
CAT I
IEC Measurement Category I – CAT I equipment designed to
protect against transients in equipment on circuits not directly
connected to MAINS. Under no circumstances should the
terminals of the Analyzer be connected to any MAINS voltage.