Foxconn 6627MA-RS2H User Manual
Page 43
Chapter 3 BIOS Description
36
v
Onboard FDC Controller
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
v
Onboard Serial Port 1/2
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port 1/2.
v
UART Mode Select
Use this option to select the UART mode. Setting values include Normal,
IrDA, ASKIR and SCR. The setting value is determined by the infrared module
installed on the board.
v
UR2 Duplex Mode
This option is available when UART 2 mode is set to either ASKIR or IrDA. This
option enables you to determine the infrared function of the onboard infrared
chip.
v
Onboard Parallel Port
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ).
v
Parallel Port Mode
Select an address and corresponding interrupt for the onboard parallel port.
v
ECP Mode Use DMA
Select a DMA Channel for the parallel port when using the ECP mode. This
field is only configurable if Parallel Port Mode is set to ECP.
Onboard SuperIO Device Menu
PDF 文件使用 "pdfFactory" 试用版本创建