HB Optoelectronic HBP200 - Manual (Page 3)

HBP200 DLP Pico Projector User Guide
1
Chapter 1 Important Safety Information
FCC Notice
1. Caution: Modification not expressly approved by the company could void the user’s authority to operate the equipment.
2. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the radio or television off and on, the user is encouraged to try to correct interference by one or more of the
following measures:
A. . Reorient or relocate the receiving antenna.
B. . Increase the separation between the equipment and receiver.
C. . Connect the equipment into an outlet on another circuit.
D. . Consult the dealer or an experienced radio/TV technician for help.
Important Safety Information
1. To ensure reliable operation of the projector and prevent overheating, make sure the projector is properly ventilated during use