HiTi P720L - Manual (Page 13)

English
HiTi P720L user manual
Chapter 2. Installing and Set Up
2 - 8
7. Close the front cover.
After each paper roll is loaded/replaced, 4
sheets of paper will automatically be ejected to
prevent dust and finger print.
ƦLoading Paper Tray
ƦTransporting the Printer
Attention: When you use 10x15 (4x6”)-size paper, you may stack about 50 prints on this
paper tray.
When using the print paper of 15x23 (6x9”), it is recommended not to install
the paper tray.
It is recommended to remove the prints stacked on the paper tray frequently. If
the prints are not removed frequently, a paper jam may occur.
The following cautions are necessary in transportation of the printer.
Since an incorrect transportation method causes a printer fault, follow the correct method.
1. Remove the ink ribbon and paper from the printer before transporting the printer.
If the ink ribbon or paper cannot be removed due to a fault, consult with the dealers or service
center.
2. Use a genuine box.
If the box used at the purchase cannot be used, consult with your dealer or service center and
purchase a new box.
3. Do not turn off the power while the front cover is open.
Close the front cover while the power is ON and turn off the power when " Ribbon Missing " is
displayed on the LCD of the operation panel.