ifm electronic JN2300 - Manual (Page 22)

Inclination sensor JN
22
The default setting of the programming key is:
j4w+ZEgRKHAl5Y8=
11 Status LED
The integrated LED indicates the current device state�
LED colour Flashing frequency Description
Green Permanently on The device is in the "run" state
12 Maintenance, repair and disposal
The unit is maintenance-free�
► Dispose of the device in accordance with the national environmental
regulations�
13 Approvals/standards
The CE declaration of conformity and approvals can be found at:
www.ifm.com → Data sheet search → JN2300
14 Factory setting
Index Type Value Delivery
0x1000 u8 TxPGN0 active 1: is sent cyclically
0x2000 u8 Device address 25
0x2001 u16 Baud rate 250 Kbits
0x2040 u8 Flag for quadrant correction 2: corresponds to "0° ��� 360°”
0x2041 u8 Flag for heating 1: corresponds to "heating on"
0x2042 u8 Index teach value of the X/Y/Z axes 2: corresponds to "absolute measurement"
0x2043 u8 FIR filter step 2: corresponds to "FIR lowpass 5Hz"
0x2044 u8 Angle calculation 0: corresponds to "perpendicular"
0x2045 u8 CAN 120 Ω terminating resistor 1: corresponds to "activated"
0x2046 u8 Set zero point of the X/Y axes 2: corresponds to "absolute measurement"
0x2047 u8 Output value 0: corresponds to "angle"
0x2048 u8 Axis selection 7: corresponds to "X/Y/Z" activated
0x2049 u8 FIR filter for V_eff 5: corresponds to "10���400 Hz"
0x204A u8 Measuring range for V_eff / a_Peak 2: corresponds to "8g”