ilve Built-in Cooktop - Manual (Page 21)

Ensure when fitting the elbow supplied with the appliance that the sealing washer is used to
prevent gas leaks.
Warning: on the cooking top, it is forbidden to carry out the gas connection by means of the rubber
flexible pipe fixed onto the rubber hose, as it is not possible to inspect the pipe.
Warning: Once the installation has been completed check if there is any gas leakage by using soapy
water or other suitable leak detection fluids.
DO NOT USE FLAMES TO CHECK ANY GAS LEAKAGES.
Installation - Electrical Connection
BEFORE CONNECTING THE PLUG INTO THE POWER SOCKET, FOLLOW THESE INSTRUCTIONS
The electrical supply for the upright cooker must be a 240 volt 50 Hz. The fuse and electrical wiring of the
home / premises must support the load of the appliance.
The hotplate must be earthed. Connect the hotplate to a properly earthed and rated power socket, as
appropriate. The flexible cord of the appliance must not be subject to direct heat and must be positioned
after installation of the hotplate so that its temperature does not exceed 75°C.
IMPORTANT if a power socket needs to be installed or relocated, the work must be done by a
licensed electrician.
Buil
t-in cooktops
21 ILVE Built-in Cooktop Operating & Installation Manual