JLCooper MCS3 USB - Manual (Page 7)

7
Reload Driver
There may be times when you need to reload the driver. To
reload the driver simply means to quit the driver and load it
again. For example, if you change COM Port settings in the
Preferences, you will need to re-load the driver. To Reload the
Driver, select Reload from this menu.
Exit
Selecting Exit Unloads the Driver. If you select Exit, the Driver
will unload and the icon will go away. To reload the driver
and begin using the MCS3 again, you will need to Restart the
computer.
Launching the MCS
3
Software Application
The application is launched either from the Windows
Start Menu or by right-clicking on the MCS
3
icon in the
Windows system tray and choosing “Open MCS3 Editor”.
MCS
3
Shuttle LEDs
Normally, on power up, the shuttle ring LEDs will not light
until the shuttle ring is centered.
After that, the shuttle ring LEDs will light depending upon the
direction of rotation from center. Both LEDs are on when the
ring is centered.
V/Stick
The V/Stick is located to the upper right of the jog/shuttle
control. It is a soft, four position switch.
The switch is activated by applying pressure either left, right,
toward you, or away from you. (It is not necessary to press
down or rotate the control.)
Like the other MCS
3
keys, it can be assigned to send a key
press or a mouse click.
Typical assignments include arrow keys, home and end keys,
page up and page down, etc.