Kanguru U2D - Manual (Page 35)

33
5.10 Most Var. Cap
The MOST VAR. CAP setting is specifically for the SMART function. In SMART mode, the system will
check the capacity of each connected Target drive. The MOST VAR. CAP setting defines the tolerance
range for different Target capacities. Tap the ‘RUN’ button to adjust the tolerance range.
• [0%] – All targets must be exactly the same capacity. Any Target that has capacity larger than the
smallest capacity Target will not be included when the SMART function is executed.
• [1-20%] – Any Target that has a capacity that is larger than the smallest capacity Target by the
percentage defined (3% by default) will not be included when the SMART function is executed.
5.11 Need Resize
The NEED RESIZE setting is specifically for the SMART function. In SMART mode, the system will
check the capacity between the Source and Targets. If the capacity between the Source and Target is
different, the NEED RESIZE setting will determine whether the system will run in Brief or Resize mode
when the SMART function is executed
• [0%] – If the capacity of the Targets is larger than the capacity of the Source then the system will
run in Resize mode when the SMART function is executed.
• [1-20%] – If the capacity difference between the Target and Source falls below the percentage
defined here (3% by default) then the system will run in Brief mode when the SMART function is
executed. If the capacity difference between the Target and Source exceeds the percentage defined
here then the system will run in Resize mode when the SMART function is executed.
Most Var. Cap / Need Resize