Kanguru Optical Duplicator - Manual (Page 41)

41
3.13.10 ISRC
The ISRC setting allows you to turn the ISRC function On or Off. Turning On ISRC allows the system
to copy the ISRC information from an audio CD. ISRC (International Standard Recording Code) is the
serial number for audio tracks that uniquely identifies a music recording. This ISRC code is common in
commercial audio CDs and is rarely seen on home made audio CDs. The default setting is Off.
Note: Enabling the ISRC function will lower the duplication performance.
Setup
10. ISRC
ISRC :
Off
1. From the Setup Menu, press the UP or DOWN button
to navigate to ISRC. Press the ENT button to enter the
ISRC menu.
2. Press the UP or DOWN button to select On or Off. Press
the ENT button to confirm your selection. You will exit
to the Setup Menu.
3.13.11 Disable Drives
The Disable Drives setting allows you to disable a specific Writer drive. This is useful when a drive is
producing copies with a high rate of failure or if a drive is not functioning properly. By default, all writer
drives are Enabled.
Setup
11. Disable Drives
Drive 1 Port 1.0
[ ] Enable [ ] Disable
1. From the Setup Menu, press the UP or DOWN button
to navigate to Disable Drives. Press the ENT button to
enter the Disable Drives menu.
2. Press the UP or DOWN button to select a Writer drive.
The Writers drives are ordered from the top to bottom
(i.e. top most Writer is Drive 1, the Writer below is Drive
2, etc..) Press the ENT button to disable the selected drive
or press the ESC button to enable the selected drive.
3. When you have finished enabling/disabling the Writer
drives, press the UP or Down button until you see the
Save Change screen.
4. Press the ENT button to save the changes. After 2 - 3
seconds the system will prompt you to restart. These
changes will not take effect until you restart the system.
Press any button to exit to the Setup Menu.
٭
Save Changes?
OK?
Setting Saved
Please Restart!
ISRC / Disable Drives