Kleenmaid ZSGS420IBS - Manual (Page 12)

Rotate
Clockwise
To Remove
Filter
Bypass
Plug
Mounting
Bracket
50 x 100 mm
Cut 900 mm
Length
Installation
Height
From Floor
Screws Mounted into
Vertical Wall Studs
Installation Instructions
12
STEP 2A INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEMS
Skip this step if you do not have a household
water filtration system.
If the water supply to the refrigerator is from any
household water filtration system, the filter cartridge
should be removed. For better ice and water
performance, remove the filter and install the filter
bypass plug.
STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels
If you are using 6 mm side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener
strips before setting refrigerator in place.
STEP 4 INSTALL ANTI-TIP BRACKETS
WARNING:
ANTI-TIP PRECAUTIONS
The refrigerator is top-heavy and must be secured to
prevent the possibility of tipping forward.
ATTENTION:
PRECAUTIONS CONTRE LES
BASCULEMENTS
Le réfrigérateur est beaucoup plus lourd en haut et il
faut le maintenir en place pour éviter la possibilité de
son basculement vers l'avant.
• Cut a 50 mm x 100 mm x 900 mm timber block.
Secure the block to the mounting brackets provided
using 6 mm wood screws.
• Secure the bracket with timber block to the back
wall so that it is 2134 mm (or your installation
height) from the finished floor. Use 6 mm wood
screws.
• Screws must penetrate at least 25 mm into vertical
wall studs.
Important Note: When the refrigerator is installed under a soffit or if
there is not enough height for this method of security, brackets cannot
be used. Proceed to step 6 to level the refrigerator and then to step 7
to secure refrigerator to cabinets. The refrigerator must be secured to
prevent tipping.
Block
Soffit
Side View
Height
From
Floor
to
Bottom
of Wood
Block
Brackets
Required
Brackets
Not Required
Beneath a
Soffit