Kleenmaid ZSGS420IBS - Manual (Page 13)

13
Installation Instructions
STEP 6 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
• To level the back of the refrigerator, turn the
7/16" hex nut located above the front wheels.
Turn clockwise to raise or counterclockwise to
lower the refrigerator.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of refrigerator to match installation
cutout opening 2121 mm to 2146 mm. The
refrigerator should be level and plumb with
cabinetry.
Hex Nut Adjusts
Rear Wheels Leveling Leg
CAUTION:
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 25 mm.
If the installation requires more than 2146 mm
height, the installer should elevate the refrigerator
on a sheet of plywood or runners. Cabinetry trim
could also be added across the top of the opening to
shorten the opening. If you attempt to raise the
refrigerator more than 25 mm, you will damage the
front leveling legs and the rear leveling wheels.
PRUDENCE
Les roues de nivellement arrière et les pattes de
nivellement avant permettent un réglage maximal
de 25 mm. Si l’ouverture pour le réfrigérateur a une
hauteur supérieure à 2,15 m, l’installateur doit élever
le réfrigérateur sur une feuille de contre-plaqué ou
des glissières. Il est également possible d’ajouter des
baguettes de finition des placards sur le haut de
l’ouverture afin de la réduire. Lever le réfrigérateur
de plus de 25 mm endommage les pattes de
nivellement avant et les roues de nivellement arrière.
STEP 5 OPEN GRILLE PANEL,
CONNECT POWER
The grille panel is secured to prevent access to the
components. Release the grille panel security screws
for installation of the additional anti-tip screws, access
to the power cord and to install the custom panel. The
grille panel security screws must be reinstalled when
these steps are completed.
• Open both doors.
• Insert a #2 Phillips screwdriver into the openings
on each side, below the top trim. Remove the grille
panel security screws and set aside.
• Raise the grille panel.
• Remove the access cover at the top back side of the
refrigerator.
• Plug power cord into the receptacle.
• Push the refrigerator back into the opening about
half way. Reach into the opening at the back and
grasp the power cord. Pull the power cord into the
opening as you gently push the refrigerator back
against the wall. Push with hands against the front
corners of the refrigerator.