Kleenmaid ZSGS420IBS - Manual (Page 9)

DISPENSER MODELS:
RAISED OVERLAY PANEL DESIGN
Design Guide
When a raised panel design is to be used, a
custom wide middle rail is required to accept
the dispenser trim.
• The middle rail must be wide enough to allow
for the dispenser trim to overlap the opening.
• The middle rail must be 28 mm total thickness
to accept the dispenser trim.
9
DISPENSER TRIM FIT EXAMPLES:
(NOT TO SCALE)
6 mm FRAMED PANEL
• The dispenser trim fits over the
custom panel and snaps into the
freezer door.
• The clips will not engage the door
if the panel is more than 6 mm thick.
• If the panel is less than 6 mm thick,
a noticeable gap may be created
around the dispenser trim.
19 mm OVERLAY PANEL
• The dispenser trim fits over the
custom panel and snaps into the
freezer door.
• The clips will not engage the door if
the panel is more than 28 mm thick.
• If the panel is less than 28 mm thick,
a noticeable gap may be created
around the dispenser trim.
6 mm Backer Panel
3 mm Spacer
19 mm Overlay Panel
Wide
Middle
Rail is
Required
Dispenser
Trim
425 mm
270 mm
6 mm
Framed
Panel
6 mm Backer Panel
3 mm Spacer
Panel
6 mm Dispenser Trim
19 mm Overlay Dispenser Trim
19 mm Overlay
Panel
FREEZER DOOR
FREEZER DOOR
6 mm
Thick
28 mm
Total Thickness
Ice / Water Dispenser
Ice / Water Dispenser