La Crosse Technology Kcombo5 - Manual (Page 12)

21
To wall mount:
Before wall mounting, please check that the outdoor
temperature values can be received from the desired
locations:
1. Fix a screw (not supplied) into the desired wall,
leaving the head extended out by about 5mm.
2. Hang the Temperature Station onto the screw.
Remember to ensure that it locks into place before
releasing.
POSITIONING THE REMOTE TEMPERATURE TRANSMITTER:
The remote temperature transmitter can be placed onto any
flat surface or wall mounted using the bracket which doubles
as a stand or wall mount base.
22
To wall mount:
1. Secure the bracket onto a desired wall using the
screws and plastic anchors.
2. Clip the remote temperature transmitter onto the
bracket.
Note:
The mounting surface can affect the transmission range.
If, for instance, the unit is attached to a piece of metal, it
may then either reduce or increase the transmitting
range. For this reason, we recommend not to place the unit on any metal
surfaces or in any position where a large metal or highly polished surface
is in the immediate vicinity (garage doors, double glazing, etc.). Before
securing in place, please ensure that the Temperature Station can receive
the 915MHz signal from the temperature transmitter at the positions that
you wish to place them.
23
CARE AND MAINTENANCE:
x Extreme temperatures, vibrations and shocks should be avoided as
these may cause damage to the unit and give inaccurate forecasts
and readings.
x When cleaning the display and casings, use a soft damp cloth only.
Do not use solvents or scouring agents as they may mark the LCD
and casings.
x Do not submerge the units in water. Furthermore, fix all parts in
place where the units are adequately protected against moisture
and rain.
x Immediately remove all low powered batteries to avoid leakage and
damage. Replace only with new batteries of the recommended
type.
x Do not make any repair attempts to the unit. Return them to their
original point of purchase for repair by a qualified engineer.
24
Opening and tampering with the unit may invalidate their
guarantee.
x Do not expose the units to extreme and sudden temperature
changes, this may lead to rapid changes in forecasts and readings
and thereby reduce their accuracy.
SPECIFICATIONS:
Temperature measuring range
Indoor
: -3.8.ºF to +139.8ºF with 0.5ºF resolution
(“OF.L” displayed if outside this range)
Outdoor : -39.8ºF to +139.8ºF with 0.1ºF resolution
(“OF.L” displayed if outside this range)
Indoor Temperature checking interval : every 20 seconds
Outdoor data checking interval : every 4 seconds
Power consumption
Temperature Station
: 2 x AAA, IEC LR3, 1.5V