La Crosse Technology Kcombo5 - Manual (Page 8)

5
The Temperature Station
x Manual time setting (hour and minute display)
x Time display 12 -hour time format
x Indoor and outdoor temperature reading in degree Fahrenheit (°F)
x Display MIN/MAX indoor and outdoor temperature display
x Low battery indicator
x Wireless transmission at 915 MHz
x Signal reception intervals at 4 seconds
x Wall mounting or table standing
6
The Outdoor Temperature Transmitter
x Remote transmission of outdoor temperature
to Temperature Station by 915 MHz signals
x Rain proof casing
x Wall mounting and table-standing
x Mounting at a sheltered place. Avoid
direct rain and sunshine
SETTING UP:
Note: this temperature station can only receive one transmitter only.
1. First, insert the batteries to the transmitter (see “How to install and
replace batteries in the Temperature transmitter” below).
2. Within 30 seconds of powering up the transmitter, insert the
7
batteries to the Temperature Station (see “How to install and
replace batteries in the Temperature station” below). Once the
batteries are in place, all segments of the LCD will light up briefly.
Following the indoor temperature, the time as 12:00 will be
displayed. If they are not shown in LCD after 60 seconds, remove
the batteries and wait for at least 60 seconds before reinserting
them. Once the indoor data is displayed user may proceed to the
next step.
3. After the batteries are inserted, the Temperature Station will start
receiving data signal from the transmitter. The outdoor temperature
should then be displayed on the Temperature station. If this does
not happen after 2 minutes, the batteries will need to be removed
from both units and reset from step 1.
4. In order to ensure sufficient 915 MHz transmission however, this
should under good conditions be a distance no more than 200 feet
8
(60 meters) between the final position of the Temperature Station
and the transmitter (see notes on “Positioning” and “915 MHz
Reception”).
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE STATION
The Temperature Station uses 2 x AAA, IEC LR3, 1.5V batteries. When
batteries will need to be replaced, the low
battery icon will appear on the LCD. To
install and replace the batteries, please
follow the steps below:
1.
Lift up the battery compartment cover.
2. Insert batteries observing the correct
polarity (see marking).
3. Replace compartment cover.