La Crosse Technology Kcombo5 - Manual (Page 2)

5
 Low battery indicator
 Wireless transmission at 915 MHz
 Signal reception intervals at 4 seconds
 Wall mounting or table standing (removable table stand included)
The Outdoor Temperature Transmitter
 Remote transmission of outdoor temperature to Temperature
Station by 915 MHz signals
 Rain proof casing
 Wall mounting and table-standing
 Mounting at a sheltered place. Avoid direct rain and sunshine
SETTING UP:
Note: this temperature station can only receive one transmitter.
1. First, insert the batteries to the transmitter (see “How to install and replace batteries in the
Temperature transmitter” below).
6
2. Within 30 seconds of powering up the transmitter, insert the batteries to the Temperature Station
(see “How to install and replace batteries in the Temperature station” below). Once the
batteries are in place, all segments of the LCD will light up briefly. Following the indoor
temperature, the Weather Girl icon and the time as 12:00 will be displayed. If they are not shown
in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before
reinserting them. Once the indoor data is displayed user may proceed to the next step.
3. After the batteries are inserted, the Temperature Station will start receiving data signal from the
transmitter. The outdoor temperature should then be displayed on the Temperature station. If
this does not happen after 2 minutes, the batteries will need to be removed from both units and
reset from step 1.
4. In order to ensure sufficient 915 MHz transmission however, this should under good conditions
be a distance no more than 200 feet (60 meters) between the final position of the Temperature
Station and the transmitter (see notes on “Positioning” and “915 MHz Reception”).
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION
The Temperature Station uses 3 x AA, IEC LR6, 1.5V batteries. When batteries will need to be
replaced, the low battery icon will appear on the LCD. To install and replace the batteries, please
follow the steps below:
7
1. Lift up the battery compartment cover.
2. Insert batteries observing the correct polarity (see marking).
3. Replace
compartment cover.
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The Temperature transmitter uses 2 x AAA, IEC LR3, 1.5V batteries. When
batteries will need to be replaced, the low battery icon will appear on the LCD of
the Temperature Station. To install and replace the batteries, please follow the
steps below:
1.
Remove the battery compartment cover.
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery holder to the unit.
8
Note:
In the event of changing batteries in any of the units, all units need to be reset by following the setup
procedures. This is because a random security code is assigned by the transmitter at start-up and this
code must be received and stored by the Temperature Station in the first few minutes of power
supplying.
BATTERY CHANGE:
It is recommended to replace the batteries in all units regularly to ensure optimum accuracy of these
units. (Battery life –see Specifications)
Please participate in the preservation of the environment. Return used batteries to an
authorized depot.
FUNCTION KEYS:
The Temperature Station has only two easy to use function keys.
+ key SET key