LD Systems LAX 16 D - Manual (Page 15)

15
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
INSTALLATION AND CONNECTION
Now that you have familiarized yourself with the functions of the LAX16D mixer, you should have no trouble
using it. Nevertheless, we recommend that you read the following section carefully. It contains important infor-
mation about how to obtain the best results with your mixer.
#FGPSF
DPOOFDUJOH
NJDT
PS
JOTUSVNFOUT

NBLF
DFSUBJO
UIBU
UIF
DIBOOFM
BOE
."*/
.*9
GBEFST
PG
UIF
-"9%

mixer are set to minimum (all the way down).
- Make certain that all external devices such as mics, power amplifiers, speakers, effects processors, etc. are
connected properly.
- When running cables, take care not to injure anyone or damage the equipment.
- Set the output level of your mixer and the connected power amplifier to no more than 75%.
- Do not set the PHONE/CONTROL ROOM level higher than 50%.
- Set the EQ controls (HI, MID, LOW) to the middle position.

4FU
UIF
QBOPSBNB
BOE
CBMBODF
LOPCT
1"/#"-

UP
UIF
NJEEMF
QPTJUJPO
- While speaking into each connected mic (speech or vocals) or playing the instrument, adjust each channel
fader (LEVEL) so that the peak LED of the corresponding channel comes on only occasionally. This will ensure
that there is always enough headroom and dynamic range available.
- You can shape the sound of the individual signals using the respective channel equalizer.
- Repeat this sequence of steps for all of the input channels being used, always keeping an eye on the LED level
meter
(OUTPUT LEVEL) so that it does not swing too far into the red area.
AUDIO CONNECTIONS
The LAX16D mixer offers numerous, highly flexible possibilities for balanced or unbalanced connection of your
equipment via XLR and 6.3 mm TRS connectors. These are explained below.
WIRING CONFIGURATION
The XLR and 6.3 mm TRS connectors of the LAX16D permit balanced and unbalanced connections depending on
the equipment connected. Examples for wiring your system:
INSTALLATION AND CONNECTION: