Marantz PM-15S2 - Manual (Page 25)

19
ENGLISH
NAMES AND FUNCTIONS
BASIC CONNECTIONS
BASIC OPERA
TIONS
ADV
ANCED CONNECTIONS
ADV
ANCED OPERA
TIONS
TROUBLESHOOTING
OTHERS
ADV
ANCED OPERA
TIONS
ADVANCED OPERATIONS
ATT (ATTENUATION)
VOLUME
ENTER
DISPLAY ATT -
ATT button
ATT button
ATT is a one-touch feature for reducing the volume level. When
the ATT button on either the unit or remote controller is pressed,
the volume level is attenuated.
1. When the ATT button on either the unit or the remote
controller is pressed, “ATT” flashes on the display and
the volume level is reduced.
When the ATT button is pressed again or the volume
is increased/decreased using the controls, the mode is
canceled and the original volume level is restored.
2. When the ATT button is pressed with the volume level at
-∞(muted), the display will change as it is shown below
appears for about 3 seconds, and attenuation is not
applied.
7
How to Set Attenuation Level
Attenuation level can only be set using the ATT button on the
unit. The attenuation level can be set at –20dB, -40dB, or -∞.
The factory default setting is -20dB.
1. Press and hold the ATT button on the unit for 2 seconds or
longer. The attenuation level will appear on the display.
2. The attenuation level setting value changes with each
press of the ATT button on the unit.
3. When the desired attenuation level setting appears on
the display, leave it unchanged for 2 seconds or longer
to enter the setting. Once entered, the display returns to
the volume level indication.
HOW TO OPERATE THE SIDE
ILLUMINATION
DISPLAY button Illumination Lamp
The illumination lamp has an always-ON mode (factory setting)
and an always-OFF mode.
In the always-ON mode, the illumination lamp turns ON/OFF
in sync with the display.
1. With the illumination lamp lit, press and hold the DISPLAY
button for 3 seconds or longer. The illumination lamp goes
out, and the always-OFF mode is engaged.
2. To cancel the always-OFF mode and turn the illumination
lamp ON, press and hold the DISPLAY button for 3
seconds or longer.
Note:
Setting of the illumination lamp cannot be performed with the
remote controller.
PM-15S2_UN_01_Eng.indd 19 PM-15S2_UN_01_Eng.indd 19 09.5.18 2:57:03 PM 09.5.18 2:57:03 PM