MBM Corporation 82 - Manual (Page 11)

Stapler Folder Model 82 Operator Manual
T10136
1. Select program on the Control panel:
Edge stapling, only Folding or Stapling/Folding.
2. Open the top cover and press the Run/Adjustment button to
access the Sheet length adjustment buttons on the Control
panel.
3. Adjust the front and rear Side guide to the paper width that
will be used. Adjust the side guides by squeezing at the
green marks on the release handles.
4. Release the Docking assembly to shift the positioning of the
Model 82 in order to align the green stripe on the collator
with the green mark on the rear Side guide.
5. Adjust the sheet length slightly larger than the paper size
being used.
Close the top cover.
6. Feed one test set into the Model 82.
7. Open the top cover and adjust the sheet length so that the
trail edge of the set just about touches the backjogger.
8. Check that the set is not squeezed so it buckles between the
side guides. The side guides should just about touch the set.
Fine adjust the Side guides if necessary.
Close the top cover and push the Run / Adjustment button to
exit the Adjustment mode. The set will be processed though
the machine.
4.2 Setting / Changing paper size
Program
select
button
Run/Adjust-
ment button
Run/Adjust-
ment button
4-2
Sheet length
adjustment
buttons