MBM Corporation 82 - Manual (Page 14)

Stapler Folder Model 82 Operator Manual
T10136
1
2
3
1. Switch the power switch to OFF (0) position. Open the Top cover
on the Model 82. Disconnect the Staple indication lead (1) from
the socket.
2. Hold the Stapler head in place, press the Release lever (2) to
release the rear end of the stapler head and lift up this end.
3. Lift out the head, allowing it to rotate around the front end. The
Stapler assembly is spring loaded and will follow the rotation of
the Stapler.
4. Remove stapler cartridge. Look inside stapler head to locate
jammed staples by eject point. Remove staples if any.
5. Position the Stapler head over the edge of a firm surface (for
example, the top of a table or the Model 82).
6. While securely holding the head, actuate the Stapler up and down
through full travel. Perform this operation first without staple
cartridge then with staple cartridge. Repeat this a few times to
ensure that the staples are ejected at each down movement.
NOTE: Actuation must be performed without excessive force. If binding
occurs there may be broken staples inside. Dis-assembly may be
required.
7. To reinstall the Stapler head, insert the pin at the top of the stapler
head into the Stapler retraction swing arm (3).
8. While rotating the Stapler head, insert the pin located at the rear
end of the Stapler head into the slots in the frame of the Stapler
head assembly. Press down the rear end of the Stapler head until
the release lever (2) snaps into place, locking the Stapler head in
position.
9. Press down the front end of the Stapler head until it snaps in
position under the frame assembly.
10. Reconnect the Staple indication lead (1).
5.2 Replacing the Stapler head / Clearing staple jam
5-2