MBM Corporation TRIUMPH 4850 - Manual (Page 31)

- 31 -
2.
A
1.
A
4.
5.
1.
3.
2.
Close the safety guard (1.) Lower the blade by
pressing both cutting buttons (2.). Keep one
button pressed and turn off the main switch (3.).
Open the safety guard (4.). With the special
wrench (B) the 3 eccentrics should be screwed
down (5.)until the paper is cut along the
entire length of the blade (The blade must
remain parallel, not too deep into cutting stick).
• Blade and cutting stick replacement •
Tighten the blade screws (A) on the right hand
side.
Turn main switch to position "I" (1.). Blade will
return to upper position. Tighten the blade
screws (2.) firmly.
Warning by IDEAL 4815
Do not turn main switch to position
"0" whilst blade is moving upwards! The
clamp must always overlap the blade!
(see page 32).
Danger! Risk of injury!