MBM Corporation 5221-EC - Manual (Page 11)

IDEAL 4810-95 EP; IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
11
03-01-10 B5221G2w.doc
4. Maintenance
s Danger
- Maintenance work may only be performed by
trained staff.
- Replacement of blade and cutting stick may
only be performed when the main switch is
switched off.
- Disconnect from the mains before starting
any service work or before removing the
cover.
Safety check
According to § 40 VBG 7i a safety check,
according to the safety stipulations, has to be
made every 5 years by a service team
authorised by our service department. The
check must be attested on the test certificate. A
corresponding test label must be visible and
affixed to the machine. This safety check is
required in Germany and we recommend it for
all countries.
4.1 Cutting stick replacement
If the last sheet of paper of a stack is not
completely cut, the cutting depth must be
adjusted.
Setting the cutting depth
- Turn the screw (9) a half turn to right.
- Perform cutting test as described below
If the cutting stick (2) is very worn it must be
turned.
l Warning!
Too deep cutting into the cutting stick
shortens the life time of the blade.
Turning or replacing the cutting stick
- Turn the screw (9) to the left until it stops.
Then a turn to the right.
- Dismount cutting stick (2).
- Turn the cutting stick (the non-used side must
be close to the blade) and plug it into the
holding bolt.
The cutting stick can be used eight times.
Cutting test
- If the last sheet of paper of a stack is not cut
over its total length, turn the screw (9) a half
turn to the right.
- Repeat this procedure until the paper is cut
over its total length.