MBM Corporation 5221-EC - Manual (Page 5)

IDEAL 4810-95 EP; IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
5
03-01-10 B5221G2w.doc
2. Installation
The machine must be installed on a sturdy,dry
and level floor.
s Danger!
- The machine must not be located outside.
- Do not use in the vicinity of inflammable
liquids or gases.
- Do not use in humid environments.
- Protect mains cable against heat, oil and
sharp edges.
6 strong people are required to lift the machine
from the pallet.
IDEAL 5221 - For further transportation
For further transportation it is possible to use a
pallet truck. Wooden covers on front and back
must be removed to transport with pallet truck.
For transport through narrow doors:
- Remove the wooden side covers.
- Remove machine from the base (4 screws).
- The machine can be transported on its side.
- Mount the machine on the base.
- Fix the side covers.
2.1 Preparing for Installation
IDEAL 5221
The machine is delivered ready for operation.
As an option side tables, left and right are
available. These should be mounted so that the
surfaces are level with the main table.
IDEAL 4810, 4850 and 6550
- Place the machine on the enclosed stand (8)
and secure with the 4 screws.
- Place the shelf (9) in the stand.
2.2 Power supply
The manufacturer's plate is located at the rear
of the machine.
- Data stated on the plate
- Voltage “ V “,
- Frequency “Hz”,
- Power consumption “A”
must correspond to the values of the power
supply unit.
- Earth wire must be available.
- Connect the machine to the mains.
Standard machines are factory-set as follows:
Voltage 220 - 240V (110V - 120V) 1 phase
Frequency 50Hz (60Hz).