MBM Corporation 5221-EC - Manual (Page 9)

IDEAL 4810-95 EP; IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
9
03-01-10 B5221G2w.doc
3.3 Programming
M
o
o
P P P P R R R R
.
5 5 5 5 7 7 7 7 . 0 0 0 0 0 0 0 0
S
This control system enables you to store 9
programs each with 9 programmable steps.
One step represents one measurement or max.
9 chain measurements. After entering the
program numbers you are able to change
between several program steps with the keys
¢
and
£
.
First figure in display = program number,
Second figure = program step.
Dimensions below 9 cm
can only be
approached with the key held pressed.
"
UL UL UL UL
" on the Display fi the entered dimension
is too low.
"
OL OL OL OL
" on the Display fi the entered dimension
is too high.
Each program step corresponds to one
dimension. The indicated program step can be
overwritten at any time. These programs
remain stored when the machine is off. Should
you change to another dimension unit all
programmed measures are converted into the
new unit (cm and inch).
Entering a program
- Press
P fi " PR PR PR PR
" appears in the Display
-
1
...
9
Enter program number 1....9.
First figure in Display = program number.
-
1
...
9
Enter dimension 1....9, or move the
backgauge to the desired measurement with
the rotary control.
-
=
store the dimension fi next program step
appears.
-
1
...
9
Enter the next dimension.
-
=
store the dimension.
-
P
+ Escape the program mode.
Eject function
Pressing the keys
=
and
¢
simultaneously for
storing the dimension forces the backgauge
first to move to the front pushing out the paper ,
and then move to the entered dimension on the
display.
Programming of repeat cut dimension
-
P
press fi " PR PR PR PR
" appears in the Display
-
1
...
9
Enter program number 1....9.
First figure in display = program number
Second figure = program step.
-
¢
...
£
Enter program step 1...9.
-
1
...
9
Enter repeat cut dimension.
-
M fi N1 N1 N1 N1
 Display shows one repeat cut.
-
M fi N1 N1 N1 N1
 Display shows two repeat cuts.
-
M fi N1 N1 N1 N1
 Display shows three repeat cuts.
-
M fi N N N N
 .... Display shows ... repeat cuts.
Maximum nine repeat cuts can be entered.
Entering the tenth repeat cut will delete the
repeat cut and the display shows the actual
program step.
-
=
store the dimension.
P
+ Escape the program mode.
Cancel a program
-
P
press fi " PR PR PR PR
" appears in the display.
-
1
...
9
enter program number 1....9.
- Key press two times.
Each program has to be cancelled separately.
Single program steps can only be overwritten.
Deleting the last program step.
- Enter
0 .
- Press
=
.
P
+ Escape the program mode.