MBM Corporation EBA 435 E - Manual (Page 24)

- 24 -
EBA 435 E • EBA 435 EP
cm
inch
cm
inch
Programming
only EBA 435 EP
This control system enables you to store 9
programs with 9 programmable steps. One step
represents one measurement. After entering
the program numbers you are able to change
between several program steps with the
button r and h .
First figure on display = program number,
Second figure = program step.
Dimensions below 9 cm can only be
approached with the S button held pressed.
„ u “ on the display the entered dimension is
too low (smallest measurement 3,5 cm).
„ o “ on the display the entered dimension is
too high (largest measurement 38,5 cm).
Each program step corresponds to one
dimension. The indicated program step can be
overwritten at any time. These programs
remain stored when the machine is off. Should
you change to another dimension unit all
programmed measurements are converted
into the new unit (cm or inch).
Entering a program
• Press p P appears on the display.
•
1 ... 9 Enter program number 1...9.
(First figure on display = program number).
• Enter dimension, or move the backgauge to
the desired measurement with the hand-wheel
control.
•
g Store the dimension next program step
appears.
If the hand-wheel G is used to approach the
cutting position press button h next program
step appears.
• Enter the next dimension.
Should an ejection be desired before this
cut push the z button.
•
g Store the dimension.
• Should the entered program be required
immediately Press S program is closed.
Press S again backgauge moves to the
dimension of the first program.
Or:
•
p + s Escape the program mode.
• Enter eject function in the first program step
if the paper stack is to be ejected at the end of
a program where several cutting processes are
made.
•
Operation
•