MBM Corporation EBA 435 E - Manual (Page 26)

- 26 -
EBA 435 E • EBA 435 EP
cm
inch
cm
inch
Working with programs
• Press p P appears on the display.
•
1 ... 9 Enter program number 1 ... 9
With the button r and h you are able to
change between several program steps.
With S the backgauge moves to the indicated
dimension.
With s the backgauge stops.
General
LED "S" blinks the basic position will appear.
LED "S" is off the actual dimension appears.
In the program mode the ejection of paper z is
not possible. The ejection of paper has to
be programmed.
After each cut press the button S the
backgauge moves to the next dimension.
Escape the program mode
• Press p P appears on the display.
• Press s escape the program mode.
Program buttons h and r programs
Button h = backgauge position rear
Button h = backgauge position front
Press p and simultaneously h ( U appears
on the display) or
Press p and simultaneously r ( D appears
on the display)
• Enter the desired dimension (For example:
21 cm x 29,7 cm can be entered for DIN A4)
•
g Store dimension.
Display in cm or inch
•
Press i Display changes between cm
and inch. (See picture left).
Adjust the eject-dimension
The eject dimension is programmed to
29,50 cm. It may be changed as follows:
• Press p , Press p , Press z e
appears on the display.
• Insert the desired dimension.
•
g Store dimension.
•
Operation
•