Montigo H42DF - Manual (Page 28)

H*42DF Indoor Gas Fireplace
Page 28 XG0148 - 150204.1
Installation
3. I nstall the new Rock Tray and front cover. Make sure the tray is not
sitting on top of the pilot.
2. Remove the Rock Guard and River Rocks from packaging.
Figure 29c. Burner Tray Front Cover
4. For Air Baffle adjustment, see "Section 3: Venting" on page 8
- NOTE section
Figure 29e. Completed Placement of Rock Guards.
5. Slide the rock guard locator tabs behind the Burner. The rocks on
the Rock Guard should line up between the air inlets of the burner.
Figure 29d. Pushing the Rock Guard down into place.
Rock Tray
Front Cover
Figure 29f. Completed Placement of Rock Guards.
Installing the Designer River Rocks:
1. Remove the glass door as described on page 21.
2. Install Rear faux "A" ceramic 3 in1 Rock as shown in Figure 29.
Back of Fireplace
Air Inlets
Figure 30. Placement 3 in 1 rear faux ceramic rock "A".
Pilot and cover
Burner holes
3 in 1 faux
Rock "A"
Rock riser
The HR42DF* is supplied with (37) thirty-seven faux ceramic fibre river
rock. Unpack the rocks and handle them very carefully. Shown Below:
Figure 30a. Placement 3 in 1 rear faux ceramic rock "A".