Montigo RX82 - Manual (Page 7)

7
FUNCTIONALITY OF THE REMOTE CONTROL
When the batteries are installed into the Remote control
the icon “little house” with the measurement of the room
temperature will be shown by the display; see Fig. 6. This
indication will always be present when the Remote Control
has battery power.
COMMUNICATION BETWEEN THE REMOTE CONTROL AND THE RECEIVER
To program the transmitter to the receiver, a small key is inserted into the hole marked PRG. The
receiver "beeps" three (3) times to indicate that it is ready to accept a new remote transmitter. As
soon as it receives the first correct command from any Proflame remote control it captures the
new address and then "beeps" four (4) times to confirm the synchronization and command execu-
tion.
FAHRENHEIT - CELSIUS TEMPERATURE INDICATION
It is possible to set the Remote Control to display the temperatures in degree either Fahrenheit or
Celsius.
With the system in OFF position, press Thermostat Key and Mode Key at the same time to toggle
from °F to °C and vice versa.
The display will show the selected unit of measure, see Fig. 7.
Fig. 6: Remote Control display.
Fig. 7: Remote Control display in Farenheit and Celsius.
TURN ON THE APPLIANCE
When the ON/OFF key is pressed, other icons (depending on the state the system when turned off)
will become visible on the LCD display. This indicates that the Remote Control is switched on. At
the same time the Receiver connects the thermopile to the as valve millivolt coil and the applian-
ce main burner turns on in the high position. An acoustic signal from the Receiver confirms the
reception of the command.
TURN OFF THE APPLIANCE
If the appliance and the Remote Control are switched on, when the ON/OFF key is pressed,the
Remote control is turned off. At the same time the Receiver removes power from the gas valve
millivolt coil and the appliance main burner turns off. An acoustic
signal from the Receiver confirms the reception of the command.