Montigo RX82 - Manual (Page 8)

8
FLAME HEIGHT
This function allows remote control of the flame height through five (5) levels.
Select the manual flame height function using the MODE key until a flame is shown to the left
corner of the display (see Fig. 8).
Use the UP / DOWN arrow key to set the desired flame height. Five flame levels are available, see
Fig. 9.
An acoustic signal from the Receiver confirms the reception of the command.
Fig. 8: flame minimum Fig. 9: flame maximum
ROOM THERMOSTAT
The Remote Control can operate as a room thermostat. The thermostat can be set to a desired
temperature to control the comfort level in the room.
To activate this function press the THERMOSTAT key this will turn the thermostat function on. The
word ON will appear to the right of the temperature bulb graphic, see Fig. 10.
Then use the UP/DOWN arrow key to set the desired room temperature, see Fig. 11. The control
system will cycle the appliance on or off to maintain the selected temperature.
Fig. 10 Fig. 11
SET TEMPERATURE
ROOM TEMPERATURE