Nevion Multicon - Manual (Page 25)

Operation 25
ID: man-multicon Multicon Manual Rev. L
Figure 6.3 illustrates the user interface for configuring a system using the Multicon web interface.
Figure 6.3 Web interface system settings
Note: Only Sublime devices may be added to a system from the Web
interface. In addition, cascaded devices are not supported.
6.2.2 Creating a System using Nevion Configurator
To view the default system configuration you need to do the following:
1. Make sure that the Nevion Configurator is installed on your PC and that the PC is at-
tached to the same subnet where the equipment resides. This is required since the Nevion
Configurator uses UDP broadcast to detect systems and devices.
2. If Nevion Configurator is not installed, download and install the application from http:
//www.nevion.com/support .
3. Open Nevion Configurator. A dialog showing detected systems will be shown.
4. Select the system you would like to open, the default system is called System1. Click OK.
Figure 6.4 Nevion Configurator open system
1. The figure below shows the default system for a Multicon that is controlling a Flashlink
sub-system.