Sansui SLEDVD329 - Manual (Page 20)

EN 20
Channel setup
This TV is equipped with a channel memory
feature which allows channels to skip up or down
to the next channel set into memory, skipping
over unwanted channels. Before selecting
channels, they must be programmed into the
TV’s memory. To use this TV with an antenna,
set the signal type option to the Air mode. When
shipped from the factory, this menu option is in
the Cable mode.
Air/Cable selection
1
Select “Channel ⇒ Air/Cable”.
2
Press ◀ or ▶ to select “Air” or “Cable”.
Air - VHF/UHF channels
Cable - CABLE TV channels
Air/Cable
Picture Sound Time Setup Lock Channel
Auto Scan
Cable
23
CH-2
Channel List
Show/Hide
Channel Number
Channel Label
NOTE:
It may take a few seconds for a digital channel
picture to appear on screen after being selected.
Auto Scan
1
Select “Channel ⇒ Auto Scan”, then press ▶ or
ENTER.
Are you sure to Auto
Scan?
No Yes
Picture Sound Time Setup Lock Channel
2
In confirmation window, Press ▶ to select “Yes”,
then press ENTER. The TV will begin memorizing
all the channels available in your area.
It may take from 15 minutes to 30 minutes to
complete memorizing digital cable channels.
Depending on the reception condition, a bar
display may not advance for several minutes,
please be patient.
If you press MENU during search, digital
channel search will stop.
•
•
NOTE:
Memorizing channels is best accomplished during
evening “PRIMETIME” hours, as more stations are
broadcasting digital signals. Memorizing channels can
only be accomplished while a station is broadcasting
a digital signal to set that channel into memory.
If you are unsure of the digital channels available
in your area, you may visit www.antennaweb.org to
•
•
•
receive a list based on your address or zip code.
Should you require further assistance you may call
our toll-free customer service line at 1-800-289-0980.
New digital channels may be added to your area
periodically, it is recommended to perform the “Auto
Scan” procedure regularly.
3
The new channel will be added into the channel
memory.
Show/Hide channel
You can select the channel that you want to skip.
1
Select “Channel ⇒ Show/Hide”, then press ▶ or
ENTER.
2
Press ▲ or ▼ to select the channel that you want
to skip.
Channel Channel Label Hide
Picture Sound Time Setup Lock Channel
4-0
7-0
12-0
23-2
23-3
23-77
23-999
CH-2
CH-3
CH-77
1/1
CH-999
Prev Next
3
Press ENTER to assign P mark for unwanted
channel.
4
Repeat steps 2 - 3 for other channels you want to
show/hide.
•
J59C0321A_EN.indd 20 J59C0321A_EN.indd 20 11/27/12 5:22:24 PM 11/27/12 5:22:24 PM