Permasteel PG-50601SRL(N) - Manual (Page 29)

26
VERY IMPORTANT: ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.
ƒ
BEFORE LIGHTING:
Inspect the gas supply hose before turning the gas “HI”. If there is evidence of
cuts, wear, or abrasion, it must be replaced before use. The replacement hose
assembly must be that specified by the manufacturer.
ƒ
VERY IMPORTANT: TO LIGHT MAIN AND SIDE BURNERS OF THE GRILL:
1) Read instructions before lighting.
2) Turn all knobs to “ OFF ” then open the tank valve. Always keep your face
and body as far from the grill as possible when lighting.
3) Open lid during lighting.
4) Push and turn any control knob slowly to “ HI ” position. The built-in igniter
will click and spark simultaneously to light the pilot and burner in
sequence. Turn the control knob to “ OFF ”IMMEDIATELY if the burner does
not light within 5 seconds. Wait 5 minutes for gas to dispel, then repeat the
lighting procedure.
5) Follow match lighting instructions if burner can’t be lit after repeating 3-4 times.
ƒ TO LIGHT MAIN AND SIDE BURNERS BY MATCH: (AS THE FOLLOWING
FIGURE SHOWS)
If the burner will not light after several attempts then the burner can be match lit.
Tools: Lighting rod (hanging behind the right door)
GRILL LIGHTING INSTRUCTION