Proel RMW1000M - Manual (Page 10)

10
Press ASC : now the transmitter is programmed to the same channel. In order to be
sure check that you have to see the same channel number on it and that the READY LED on the
receiver is ON.
IMPORTANT WARNING MESSAGES
“FULL” text can appears on the receiver LCD display when the receiver has done a complete scan of
the frequency in a group without finding any of them free. In this case select another group and
repeat the automatic channel select operation.
“INCOMPATIBLE” text can appears on the transmitter when the receiver and the transmitter
frequency ranges don’t match.
SET MANUALLY A CHANNEL GROUP
Press X 2: on LCD appears , then press to choose the
channel group from 1 to 6.
If you don’t press any button after 5 seconds the transmitter goes back to normal operation.
SET MANUALLY A CHANNEL NUMBER
Press X 3: on LCD appears then press to choose the
channel from 1 to 16.
If you don’t press a button for 5 seconds the transmitter goes back to normal operation.
SET AUTOMATICALLY THE SECOND RECEIVER
After you have set the first receiver and transmitter, leaving ON the first transmitter repeat the
operation for the second receiver and transmitter: the second receiver automatically detects the
first transmitter channel, discards its channel and selects another free channel to set the second
transmitter.
SET AUTOMATICALLY THE THIRD AND SUBSEQUENTLY RECEIVERS
Set another group every two receiver‐transmitter and, leaving ON the previous transmitters, set the
other receiver‐transmitter channels: this method DO NOT AVOID completely THE
INTERMODULATION problem but it reduces its probability.
CHECK THE FREQUENCY OF THE GROUP‐CHANNEL
Press X 4: on LCD appears , then press and hold ,
the correspondent frequency remains on the display until the button is released.