Rmw1h bodypack transmitter – Proel RMW1000M User Manual
Page 8
8
The transmitter is locked and the buttons have no effect: press “mute” and “select” together to lock
or unlock the transmitter. Locking the transmitter and the receiver prevents unwanted setting changes.
Typically the LCD shows the channel actually in use (see further on this manual for detailed
operating instructions about channel setting).
18.
or MUTE BUTTON
Press this button to MUTE (LED ORANGE) or un‐MUTE (LED GREEN) the microphone. Press and hold for 3
second to switch on and off the transmitter.
19. SELECT
Press and hold this button for 3 seconds and you access the CHANNEL selection: pressing again the
“SELECT” button you can select the channel. If you press and hold the button for another 3 seconds, you
can access the GROUP selection. If you don’t press the button for 5 seconds the transmitter goes back to
normal operation (see further in this manual for detailed operations).
20. IR
After removing the battery cover, you can access the infrared port for receiving the channel setting.
RMW1H BODYPACK TRANSMITTER
See FIG. 8 at page 16:
21. ANTENNA
This is the transmitting antenna: do not force, disconnect or try to replace with other one.
22. LCD DISPLAY
The LCD display shows various information:
the batteries are fully charged and you have 6‐8 hours of working operation using alkaline batteries.
the batteries are half charged and you have 2‐6 hours of working operation using alkaline batteries.
the batteries are almost discharged and you have 0‐2 hours of working operation using alkaline
batteries. Batteries replacement is suggested as soon as possible.
The transmitter is locked and the buttons have no effect: press “mute” and “select” together to lock
or unlock the transmitter. Locking the transmitter and the receiver prevents unwanted setting changes.
Typically the LCD shows the channel actually in use (see further in this manual for detailed
operating instructions about channel setting).
23. SELECT
Press and hold this button for 3 seconds and you access the CHANNEL selection: pressing again the
“SELECT” button you can select the channel. If you press and hold the button for another 3 seconds, you
can access the GROUP selection. If you don’t press the button for 5 seconds the transmitter goes back to
normal operation (see further in this manual for detailed operations).
24. BATTERIES COVER
Sliding down the lower part of the bodypack you can access the battery inlet and the IR receiver sensor.
25. AUDIO INPUT
T4AF mini XLR input socket to connect the supplied microphone or other microphone.
26. ON or MUTE BUTTON
Press this button to MUTE (LED ORANGE) or un‐MUTE (LED GREEN) the microphone. Press and hold for 3
second to switch on and off the transmitter.
27. STATUS LED
This LED shows the status of the transmitter: