Proel RMW1000M - Manual (Page 9)

9
OFF: the transmitter if turned off or the batteries are missing or fully discharged.
GREEN: the transmitter is on and operative.
ORANGE: the transmitter is on but muted. Press simultaneously “MUTE” and “SELECT” to change the
status between muted (orange) and operative (green).
ORANGE/RED flashing: the battery are fully discharged and must be replaced.
28. IR
After removing the battery cover, you can access the infrared port for receiving the channel setting.
OPERATING INSTRUCTIONS
BATTERY REPLACEMENT
For the Battery replacement use always 2x 1.5V AA size LITHIUM or ALKALINE type for the best
performances. You can use also rechargeable batteries but in this case the operating time is shorter.
Good quality ALKALINE batteries guarantee an operating time of about 8 hour.
To replace the batteries on the RMW1M handheld microphone follow the instructions on FIG.3 and
4, respecting always the polarity marked inside the battery inlet.
To replace the batteries on the RMW1H bodypack microphone follow the instructions on FIG.8 and
9, respecting always the polarity marked inside the battery inlet.
Always remember to remove the batteries if you don’t use the microphone for a long period of
time: this will avoid the corrosion of the battery contacts.
ADJUST RMW1M GAIN
As show in FIG.6 and FIG.7 it’s possible to set the gain of the handheld microphone: set it at 0dB for
speaking voices and at ‐10dB for singing voices.
WEARING THE BODYPACK RMW1H
As show in FIG.10 it’s possible to wear the bodypack to a belt, strap or dress vertically or
horizontally and simply turning the spring on the other side, in any case be careful don’t fold or pull
the antenna.
SET AUTOMATICALLY A SINGLE SYSTEM
Be sure that the transmitter is switched OFF.
Press on LCD appears then press , if you don’t press the
button into 5 seconds the receiver goes back to normal operation.
The receiver searches a free channel in the selected group
(note: it searches for a free frequency avoiding previously set channels or TV channels)
and when it is found a fixed channel is set
TURN ON the transmitter and expose its IR to IR of the receiver as show in FIG.11