Proel RMW1000M - Manual (Page 6)

6
INTRODUCTION
Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.
DESCRIPTION
The RMW1000 Wireless Microphone is a UHF, PLL controlled, dual antenna diversity system providing a
reliable and high quality signal transmission and equipped with automatic channel scan and IR sync.
RMW1000 Wireless Microphone system features 3 units: RMW1000 receiver, RMW1M handheld transmitter
and RMW1H body pack transmitter. The system is available in two different configurations, each of them
including an ABS carrying case:
RMW1000M: RMW1000 + RMW1M
RMW1000H: RMW1000 + RMW1H + headset microphone
96 channel frequencies are available allowing the simultaneous use of 8 devices without interference
between them (see detailed explanations further in this manual).
RMW1000 RECEIVER
See FIG. 1 at page 15:
1. ANTENNA 1
This is the first receiving antenna. Screw it in and raise it up during the use and, in order to obtain a
better reception, place the receiver away from other metal objects and distant no more than 50m from
the transmitter.
2. ANTENNA 2
This is the second receiving antenna. Screw it in and raise it up during the use. The internal diversity
receiving circuit chooses the better signal from one of the two antenna.
3. DC IN
Socket for the AC/DC adaptor connection: use only the adaptor supplied with the system.
4. OUTPUT (BALANCED)
Balanced output with mic level: connect it through a XLR cable to a mixer input. This output is used
preferably for long runs.
5. OUTPUT (UNBALANCED)
Unbalanced output with line level: connect it through a mono 6.3mm jack cable to a mixer or instrument
amplifier input. This output is used preferably for short runs.
6. VOLUME
Volume potentiometer: using a small screwdriver set this control to a proper level that doesn’t saturate
the mixer input channel.
7. POWER
On/off switch: press and hold for two seconds to switch on or off the receiver.
8. READY
Green LED: if it is on indicates that the transmitter is sending a radio signal to the receiver, if it is off the
transmitter doesn’t send a radio signal. In this case check if the assigned transmitter is off or set in
another channel.
9. AUDIO BAR LED
Shows the presence of an audio signal: note that the level indication is independent from the VOLUME
setting.
10. LCD DISPLAY
The LCD display shows various information: