Rena T-250 - Manual (Page 9)

ASSEMBLY AND INSTALLATION
Section 2 – Assembly and Installation
Assembly
The T-250 Tabber has to be assembled before it can be used. Follow the steps below to
prepare it for operation:
Step 1: Remove all the components from
the carton.
Step 2: Attach the two media support
guides using the two thumbscrews
provided. The pin on the guide fits into
the lower hole and the guide is secured
with the thumbscrew as shown.
Step 3: Install the two side guides over
the metering bracket support bar and then
tighten the thumbscrew.
Step 4: Loosen the thumbscrew. Place
the slot on the tab roll support over the
stud and slide it down until it reaches the
thumbscrew. Tighten the thumbscrew.
T-250 Operations Rev. 2/5/2010 9