Rena EasyFeed 120 User Manual
Page 19
EasyFeed_120_Operations_
4-25-14
19
RAISING THE BRIDGE TO ACCOMMODATE THICKER MATERIAL
This is only necessary when trying to use material that is thicker than ½ inch.
Raising the bridge increases the maximum thickness capability to 1 inch.
1. With a 5/32” allen wrench, remove the four button head bolts holding the bridge onto the
side-frames of the machine.
2. Align the bridge attachment holes with the upper set of holes in the side-frame, as indicated
above, then insert and secure all bolts. This will increase the maximum thickness capability
to 1 inch.
Note: If material thinner than ½ inch is used, then it will be necessary to lower the bridge again.
Upper set of
Bridge Mounting
Holes.
For very
thick material
Lower set of
Bridge Mounting
Holes.
Standard position.