Royal Vacuums CH50102 - Manual (Page 12)

seCondarY Filter:
when to replace
12
what to Buy
Use only genuine Hoover Secondary Filters with your
vacuum. When purchasing a new Secondary Filter,
ask for ® Hoover
Part No. 440001913
Filter BaG:
how to replace
4.1 To change filter bag, lift up bag door release
latch and pull out. Remove door.
4.2 Grasp plastic bag collar (A) and pull collar from
bag support frame (B). Do not pull on paper flap
seal. Paper flap will seal the bag opening automati-
cally when removed from the support frame, pre-
venting dust from being released into the air. Discard
used filter bag.
WARNING
! !
To reduce the risk of personal injury, unplug before
cleaning or servicing.
Do not use vacuum without filter bag in place.
IMPORTANT
Do not clean out old filter bag and reuse. Discard
used filter bag.
4.3 Hold new filter bag as shown. Slide plastic
bag collar into the bag support frame until the
bag is securely in place. Tuck in filter bag.
4.4 Reposition bag door by aligning tabs on bottom
of door into openings on cleaner body (C). (Make
sure the bag door release latch is lifted up, other-
wise, the bag collar will not engage and door will
not close.)
Close bag door and snap securely shut. Press down
on bag door release latch to lock into place.
secondary Filter
The secondary filter is located inside the bag com-
partment and protects the motor from dirt particles.
4.6 To change the secondary filter first remove the
bag door then slide the filter out by grasping and pull-
ing from the bottom (as shown).
4.7 Insert the new filter by lifting the metal safety lever
(A) and sliding the new filter in until it is securely in
place. Be sure to grab filter by plastic frame and finger
loop located on bottom of filter. Reattach bag door.
4.5 When the red indicator light for the filter full illuminates or the unit
is not cleaning well, the secondary filter (A) located inside the bag com
-
partment is clogged with dirt or dust; change the secondary filter.
seCondarY Filter:
how to replace
WARNING
! !
To reduce the risk of personal injury, unplug before
cleaning or servicing.
Do not use vacuum without either the secondary or
final filter in place.
NOTE: Bag door cannot be closed unless filter is
in place.
4.8 WHEN FILTER HAS BEEN REPLACED,
RESET THE “FILTER FULL” INDICATOR ON THE
LED DIAGNOSTIC PANEL (SEE PAGE 14).
Note: Bag door will not
latch without bag properly
installed.
4.1
B
4.2
A
B
4.3 4.4
C
4.5
A
4.6 4.7
A