Royal Vacuums CH50102 - Manual (Page 13)

13
Brushroll: when to Clean or replace
WARNING
! !
To reduce the risk of personal injury from moving
parts, unplug vacuum before servicing.
4.12 To remove the brushroll, tilt nozzle on its side with
brushroll side plate up. Push the brushroll release but-
ton (A) forward and remove the side plate (B).
4.13 Twist brushroll forward and lift brushroll out. If
cleaning, remove any debris and/or hair from the
brushroll. If replacing, discard old brushroll and install
a new one.
4.14 To reinstall the brushroll, slide the brushroll back
into the brush housing and twist it backwards until it
locks in place.
4.15 Press the side plate (C) back onto the nozzle,
until it locks into place.
4.16 If you’ve replaced the brushroll with a
new one, reset the brushroll check indicator
on the LED Diagnostic Panel (see page 14).
Brushroll: how to Clean or replace
When the red indicator light above the brushroll check icon illuminates and
is blinking
, the brushroll is jammed and
needs checked and cleaned.
When the red indicator light above the brushroll check icon illuminates and
stays on
, the brushroll bristles are worn
and the brushroll needs replaced.
It is also advised to check occasionally for excess hair or fiber wrapped around the brushroll.
what to Buy
Use only genuine Hoover Brushroll with your
vacuum. When purchasing a new Brushroll, ask for
Hoover
Part No. 440001916.
4.10 To remove this filter when it becomes dirty,
first release the handle all the way to the floor by
stepping on the handle release lever (B) twice.
4.11 To remove final filter, pull tab (C) forward.
Remove filter cover and filter. Insert a new filter
and replace the filter cover.
Final Filter:
how to replace what to Buy
Use only genuine Hoover Final Filters with your
vacuum. When purchasing a new Final Filter, ask for ®
Hoover
Part No.440001914.
Final Filter:
when to replace
4.9 The final filter (A) located on top of the nozzle should be changed when
clogged with dirt or dust. Inspect regularly or when changing the second-
ary filter.
WARNING
! !
To reduce the risk of personal injury, unplug before
cleaning or servicing. Do not use vacuum without
either the secondary or final filter in place.
4.9
A
4.10
B
4.11
C
4.12
A
4.12
B
4.13
4.14
4.13
4.15
C